Click to enlarge
|
This new compact design, low cost, switch mode, 4 step, constant current, single output battery charger is designed for use where only a single battery bank is to be charged. After the battery is charged the unit drops to a safe float voltage and the unit will act as a power pack, safely delivering power to feed any on board power requirements up to the maximum current of the charger (due to the reverse polarity protection of this unit, a battery must be connected to the charger with a minimal charge in the battery before the charger will activate, or become a power pack). This charger is extremely compact, and is preset so it can be used for open lead acid, sealed lead acid, gel etc, or any battery where the charger voltage should not exceed 14.4 volts.
Input voltage = A/C 180-240 v 47-63 hz
Out put voltage:
High charge voltage
Float voltage
Efficiency
Protection:
Reverse polarity protected
Short circuit protected
Overload protected
Over temperature protected
Thermostatically controlled cooling fan
Charge cycle and protection Indication:
L.E.D. R: power on G: float charger Y: high charger
L.C.D
Meter, needle type
Size in mm width height depth
Weight in kg |
yes
14.4 max
13.6
87%
yes
yes
yes
yes
yes
yes
yes
no
115x60x186
0.9 |
|
.gif)
